A simple greedy algorithm for a class of shuttle transportation problems

Greedy algorithms for combinatorial optimization problems are typically direct and efficient, but hard to prove optimality. The paper presents a special class of transportation problems where a supplier sends goods to a set of customers, returning to the source after each delivery. We show that these problems with different objective functions share a common structural property, and therefore a simple but powerful generic greedy algorithm yields optimal solutions for all of them.     

Interpolation theorems for self-adjoint operators

We prove a complex and a real interpolation theorems on Besov spaces and Triebel-Lizorkin spaces associated with a selfadjoint operator L, without assuming the gradient estimate for its spectral kernel. The result applies to the cases where L is a uniformly elliptic operator or a Schrdinger operator with electro-magnetic potential.     

两种异马来二氰基二硫烯镍(II)-取代苄基喹啉鎓盐的制备及其光谱性质和晶体结构

以甲醇为溶剂,将异马来二氰基二硫烯酸钾[K2(i-mnt)]和六水氯化镍分别与溴化4-溴苄基喹啉盐([4-BrBzQl]Br)或溴化4-硝基苄基喹啉盐([4-NO2BzQl]Br)直接反应,得到两种新的离子对配合物[4-BrBzQl]2[Ni(i-mnt)2](1)和[4-NO2BzQl]2[Ni(i-mnt)2](2);测定了其红外光谱和紫外-可见光谱,并利用X射线衍射表征了配合物1的晶体结构.结果表明,配合物[4-BrBzQl]2[Ni(i-mnt)2]为三斜晶系,P-1空间群,其每个不对称单元含半个[Ni(i-mnt)2]2-阴离子和1个[4-BrBzQl]+阳离子,晶体中的阴、阳离子通过静电作用和C-H…S、C-H…N氢键作用形成网络结构.     

HPLC–MS/MS法测定南美白对虾苗中硝基呋喃类代谢物残留

研究了南美白对虾苗中4种硝基呋喃代谢物呋喃唑酮代谢物(AOZ)、呋喃它酮代谢物(AMOZ)、呋喃妥因代谢物(AHD)、呋喃西林代谢物(SEM)的高效液相色谱–串联质谱(HPLC–MS/MS)测定方法。以水解衍生并添加4种同位素内标的方法对样品进行处理,补偿了衍生化效率,提高了定量的准确性。实验结果表明,AOZ,AMOZ的检出限为0.10μg/kg,SEM,AHD的检出限为0.25μg/kg;AOZ,AMOZ的定量下限为0.40μg/kg,SEM,AHD的定量下限为0.50μg/kg。方法加标回收率在88.2%~97.6%之间,相对标准偏差在4.6%~8.1%(n=6)之间。该法检测灵敏度高,测量结果的精密度和准确度满足药物残留检测要求。     

变频空调制冷系统流量调节性能分析和实验研究

通过实验分析不同膨胀阀开度和压缩机频率下系统性能。过热度在‘0’点及前后情况下,制冷系统性能及回油状况随膨胀阀开度调节,会出现较大变化。且在过热度为‘0’时系统制冷量和能效比最高。同时对不同频率下系统性能参数变化规律尤其是换热器效率影响进行分析。给出膨胀阀开度和压缩机变转速联合调节在系统性能最优状态下调节策略。     

清明法定假日对交通量的影响研究

2008年4月4日至6日是国家新休假办法实施以来的第一个清明假日,研究其对交通量的影响对以后清明祭扫交通管理有着重要指导意义。本文通过对西安市6个公墓2008年清明假日祭扫实地观测数据以及2007年历史数据的统计分析,建立了祭扫交通量和路段饱和度分析模型以及相关的祭扫人群组成分析模型,用以研究清明法定假日对祭扫交通量的影响。以西安地区为实例进行了模型验证,结果表明清明法定假日并未使西安地区的祭扫交通量增加,但祭扫人群的组成发生了变化;对其它8个城市在2008年清明假日的祭扫人数变化情况进行了统计,得出清明假日对各地祭扫交通影响存在差异性。最后对以后的清明祭扫活动提出建议。     

Fabrication of extreme wettability patterns with water-film protection for organic liquids

Selective fabrication of superhydrophilic (S-philic) region on a superhydrophobic (S-phobic) surface requires complex technology and high cost, which has limited applications of extreme wettability patterns. In this paper, a twice-chemical-etching approach without special modification is used to prepare the extreme wettability patterns. Superhydrophobicity and superhydrophilicity can be successfully achieved after twice chemical etching for 20 seconds. The obtained patterns can maintain their extreme wettability for at least 30 days. Functional platforms with single-S-philic and multi-S-philic regions are fabricated to manipulate water and various organic liquids with water-film protection in an air environment.     

Ultra-lightweight cellulose foam material: preparation and properties

Ultra-lightweight cellulose foams were prepared by regeneration of sodium dodecyl sulfate (SDS)/cellulose/NaOH/urea blend solution via mechanical agitation and then freeze-drying. The morphology and properties of the blend solutions and foams were investigated via optical microscope, rheometer, BET and SEM. As a result, it was found that the inclusion complex structure between cellulose macromolecules and the solvent molecules was not destroyed. Moreover, the bubbles were about 20–50 μm in the solutions and larger (>100 μm) in the foams. Not only the micropores (bubbles) but also the nanopores could be observed in the wet and dried foams. The cellulose foams possessed ultra-low density of about 30 mg/cm³ and high specific surface area. The result of X-ray diffraction and Fourier transform infrared spectroscopy indicated that the cellulose foams were transited from cellulose I to cellulose II after dissolution and gelation. Bubbles inside the wet foams weakened the mechanical properties, but inversely increased the mechanical properties in the dried foams. Typical “J”-shaped curves were observed during the mechanical test, which revealed good compressive strength of dried foams. In this work, cellulose foams with ultra-lightweight and good mechanical properties were obtained, which exhibited great potentials for further development and comprehensive utilization of cellulose.